Some helpful & useful information I discovered during today's Livestream. Watch it in full here:
✅Easy to open. Use 75C with the CPB Heating Pad:
✅You can replace the screen & encounter no negative behaviors. Outside of the "notification" that the screen has been replaced. I didn't swap over the ALS sensor, so didn't see if True Tone carried over. Face ID works!
✅SIM Slot - There's a space in there for it but the SIM slot is just missing. Instead, there is just a plastic spacer there.
✅This device uses the same exact battery connector as the 13 series, so you can use the DT880 + Mechanic iBoot Cable & it'll work.
✅You can activate it using 3u tools and skip the setup.
✅It no longer says "No SIM" in the control panel. It will just be blank.
✅No IMEI when you dial *#06#. But this phone is not activated with any carrier. So maybe that's why?
✅There are 2 longer screws for the plate holding down the plates over the screen, towards the top. So ...
If you have a Seek Thermal Cam, you're missing out if you don't have a VCC Seek Stand: https://www.vccboardrepairs.com/buy-seek-stand
Injured Gadgets just got these back in stock, so get them while you can!
It can take us a while to build these out sometimes, so they're sometimes out of stock for a while, but we're working towards always having inventory ready to build more as they sell out.
This stand makes using a thermal cam so easy. So much better than any other thermal solution on the market.
It allows you to get real close up (using my Macro Lens), and easily find where the short is coming from.
Plus it's hard free, so you can have your hands free to try to boot the device from DCPS, while having an image that is in focus & not moving around.
You can even record a video through the app, while you inject voltage into the short, so you can go back & see exactly which component was it that was heating up.
Save yourself lots of time by getting a Seek Cam, Stand & Macro Lens! ...
Anyone who is doing game console repairs, knows how many screws you need to remove to access the motherboard.
Especially the PS5, with the 5,000 screws or so.
If you don't already have an electric screwdriver, GET ONE ASAP.
🌟 Cordless Screwdriver with T9 Bit: https://amzn.to/3E5duCj
🌟Extended T9 Bit: https://amzn.to/3c4YJac
It's rechargeable through micro USB and allows you to easily swap the tips out. You can also fold it to be straight or L shape.
Let me know below if you are already using an electric screwdriver 👇👇
I was surprised this one was successful...
Hope you guys enjoy all the detail I provide in the videos!
These cloths are amazing. They're soft but don't melt when you heat them.
They're perfect for reballing ICs. Just fold it in half twice & place the IC on top.
While you're reballing, the chip will sink down a bit & allow you to reball much better than if you were to reball on your workmat
Buy them here:
⭐ Cleanroom Cloth for Reballing ICs: https://amzn.to/4hMLwzn
Let me know what you think!
